Toyota Tundra 2001 3 Cable Wiring Red Black Blue

UtzTechy [OP] New Member

Joined:

Jan 30, 2021

Member:

#58386

Messages:

5

Gender:

Male

Vehicle:

2001 White Tundra SR5 Access Cab

Hello, I tried installing a Compustar 4900s remote start / keyless entry on my 2001 Tundra Access Cab today, but ran into some trouble with the wiring.
I found this helpful thread, which I was using to follow along, until I got to the power lock and unlock part.

The wiring diagrams I continue to find (Diagram 1, Diagram 2, Diagram 3) say that the Power Lock has a White/Green cable and the Power Unlock has a Red/Yellow cable. However, when I went to find those cables in my truck, they're not there... Even found this picture while searching, but my 12 pin connector does not have the same colored wires .

Has anybody ran into this issue before?

I've attached a couple of images of what my 12 pin connector looks like. Any help would be greatly appreciated!!
KNABORES Not so new-ish Member

Joined:

Jan 1, 2020

Member:

#40572

Messages:

2,923

Gender:

Male

Arkansas

Vehicle:

2000 Limited TRD AC 4X4 Thunder Grey. 2019 Limited TRD CM 4x4 Cement Grey

2000: Bilstein 5100's 16x8 589's with 265/75/16 and 1.25" spacers Flowmaster 50 series over the axle dump Westin bull bar with 20" LED Pioneer touchscreen with backup camera Full interior and dash LED conversion Trailer brake controller with 7 pin Bedliner coat bumpers trim and tool box 2019: ARE topper with full Bedrug kit TRD shifter

The color of wires in vehicles can change from standard if say the assembly runs out of a particular color during production. They do not stop making harnesses or vehicles, they simply use another color wire. Would the pin positions not be the same? The picture you found shows which pin positions should be the correct ones. Test those wires to see if they are correct. The Blue/black appears to be in the red/yellow unlock position. The green / red appears to be in the white / green lock position.
UtzTechy [OP] New Member

Joined:

Jan 30, 2021

Member:

#58386

Messages:

5

Gender:

Male

Vehicle:

2001 White Tundra SR5 Access Cab

That is a possibility and that's what I was thinking as well. Ran out of daylight yesterday, and so, did not get onto testing the wires... figured I'd ask on here in case anybody had ran into a similar scenario. Thanks for your input!
UtzTechy [OP] New Member

Joined:

Jan 30, 2021

Member:

#58386

Messages:

5

Gender:

Male

Vehicle:

2001 White Tundra SR5 Access Cab

For anybody else that may want to install an alarm/remote start/keyless entry in their truck in the future... I ended up finding the power lock and unlock cables in the Gray 9 Pin Plug, right above the white 12 pin plug. The cables are in fact red/yellow and white/green.

tvpierce and KNABORES like this.
KNABORES Not so new-ish Member

Joined:

Jan 1, 2020

Member:

#40572

Messages:

2,923

Gender:

Male

Arkansas

Vehicle:

2000 Limited TRD AC 4X4 Thunder Grey. 2019 Limited TRD CM 4x4 Cement Grey

2000: Bilstein 5100's 16x8 589's with 265/75/16 and 1.25" spacers Flowmaster 50 series over the axle dump Westin bull bar with 20" LED Pioneer touchscreen with backup camera Full interior and dash LED conversion Trailer brake controller with 7 pin Bedliner coat bumpers trim and tool box 2019: ARE topper with full Bedrug kit TRD shifter

Glad you found the appropriate harness and got the keyless working!
tvpierce Formerly New Member

Joined:

May 6, 2019

Member:

#30129

Messages:

1,039

Maine

Vehicle:

2000 Tundra AC SR5 4WD, 4.7 Automatic

Great find. I've bookmarked this thread for my keyless install this spring.
Thanks